I did get a couple of cracks in it with time, but the putty never fell out even with pressure washing. The cracks made it look more like the wood. It didn’t take the stain the same as the real wood, but I had a big void to fill and it did the trick just fine.
I have a deck that's 12 years old pressure treated wood, stained 3 times with flood oil based stain,cedar. Outdoor Rot-Wood based epoxy products to repair and resist wood rot. We'll have more to say about decks in the repair section, but if you're building or ...
Pressure-Treated Wood Grading Standards. Many lumberyards stock treated wood in the broad category of > or better. If this is the case, you may want to sort through the lumber piece by piece to find clear, straight boards.
If there is a better forum to post this to I'd be happy to move it there. I have a cedar deck that has some failing spots and edges. I decided to try to fill the bad spots/edges with a wood filler an then coat (top only as sides and bottom are really not accessible) with Behr deck solid color stain.
Scrub the deck with a steady pressure applied to a push broom against the wood decking. Allow the cleanser to work at removing the accumulated dirt, stains and discolorations for 15 minutes.
For fully exposed decks, a water-repellent sealer or a penetrating semi-transparent stain may provide the best finishing solution, even on wood that has been pressure treated with preservatives. Special formulations made specifically for decks are available.
Treated wood is useful in outdoor structures that are consistently exposed the elements, and most wood decks use pressure-treated wood. Although highly resistant to rot, pressure-treated wood can still become cracked because of moisture and heat, or become punctured or gouged.
A pressure washer can damage the wood if used too close or if you use too much pressure on soft woods like this pressure treated pine, but I didn't care much, as the surface of the boards couldn't be much worse.
Pressure-treated wood is a nice option for low-budget decks, but does need periodic sanding and re-staining. Ipe is the most well-known type of tropical hardwood, popular for its rich brown color and durability.
Suburban Boston Decks and Porches blog ... filling splits with putty or wood fillers. ... ” The correct process is the same for pressure treated wood as for ...
You might want to fortify the wood filler a bit by taking some common wood filler and mixing in a little white glue to make it stickier. Come back a day later and sand it down. There is no real simple fix to this problem of peeling deck boards.
Wood filler in itself is like wood putty, but it has cellulose wood fibers in the product, allowing for a stronger bond than a putty. Plus, you can stain or paint over wood filler. Simply apply the areas affected with a small flexible putty knife so as to force the wood filler to fill the volume of the cracks and checks in the deck.
As soon as you expose most treated lumber to the sun and wind by nailing it to deck joists, the liquid in the wood begins to exit to the air. When the sun extracts this moisture out of the lumber, it creates significant tension stress within the wood fibers.
Another major issue with using wood filler on a deck or wood surface is the stability of the filler. Wood filler and caulk are not stable and end up cracking or breaking out of the voids. This is especially true in an area where there is a wide range of climate change.
Pressure treated decking when new has a tendency to have very annoying ink stamps on the wood when processed at the mill. Lumber is stamped at the mill according to its grade. An American Lumber Standard Committee (ALSC) grade mark and an American Wood-Preservers’ Association (AWPA) tag certify the lumber’s quality.